# $Id: rc288dpi-1,v 1.6 2004/05/03 14:18:01 lhoward Exp $ # # HylaFAX Facsimile Software # # Copyright (c) 1990-1996 Sam Leffler # Copyright (c) 1991-1996 Silicon Graphics, Inc. # HylaFAX is a trademark of Silicon Graphics, Inc. # # Permission to use, copy, modify, distribute, and sell this software and # its documentation for any purpose is hereby granted without fee, provided # that (i) the above copyright notices and this permission notice appear in # all copies of the software and related documentation, and (ii) the names of # Sam Leffler and Silicon Graphics may not be used in any advertising or # publicity relating to the software without the specific, prior written # permission of Sam Leffler and Silicon Graphics. # # THE SOFTWARE IS PROVIDED "AS-IS" AND WITHOUT WARRANTY OF ANY KIND, # EXPRESS, IMPLIED OR OTHERWISE, INCLUDING WITHOUT LIMITATION, ANY # WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. # # IN NO EVENT SHALL SAM LEFFLER OR SILICON GRAPHICS BE LIABLE FOR # ANY SPECIAL, INCIDENTAL, INDIRECT OR CONSEQUENTIAL DAMAGES OF ANY KIND, # OR ANY DAMAGES WHATSOEVER RESULTING FROM LOSS OF USE, DATA OR PROFITS, # WHETHER OR NOT ADVISED OF THE POSSIBILITY OF DAMAGE, AND ON ANY THEORY OF # LIABILITY, ARISING OUT OF OR IN CONNECTION WITH THE USE OR PERFORMANCE # OF THIS SOFTWARE. # # # Configuration for a Rockwell RC288DPi-based Class 1 modem. # Hayes Optima 28800 firmware rev ??? # Microcom DeskPorte 28.8S firmware rev V1.100K-V34_DS # PPI PM288FXMT firmware rev 1.57 # # Note that the modem does not lock the line rate for fax # receive (at least not the PM288FXMT); but not sure whether # current flow control settings are maintained or if it # switches to XON/XOFF (testing host was too fast to see). # # CountryCode: 60 AreaCode: 3 FAXNumber: "+60 3 40455307" LongDistancePrefix: 1 InternationalPrefix: 00 DialStringRules: etc/dialrules ServerTracing: 1 SessionTracing: 11 RecvFileMode: 0644 LogFileMode: 0644 DeviceMode: 0644 RingsBeforeAnswer: 2 SpeakerVolume: medium GettyArgs: "-h %l dx_%s" LocalIdentifier: "NothingSetup" TagLineFont: etc/lutRS18.pcf TagLineFormat: "From %%l|%c|Page %%P of %%T" MaxRecvPages: 25 # # # Modem-related stuff: should reflect modem command interface # and hardware connection/cabling (e.g. flow control). # ModemType: Class1 # use this to supply a hint ModemRate: 19200 # rate for DCE-DTE communication ModemFlowControl: rtscts # default # ModemNoFlowCmd: AT&K0 # setup no flow control ModemHardFlowCmd: AT&K3 # setup hardware flow control ModemSoftFlowCmd: AT&K4 # setup software flow control ModemSetupDTRCmd: AT&D2 # setup so DTR drop resets modem ModemSetupDCDCmd: AT&C1 # setup so DCD reflects carrier (or not) # ModemMfrQueryCmd: !Rockwell ModemModelQueryCmd: !RC288DPi ModemRevQueryCmd: ATI3 # product information # ModemDialCmd: ATDT%s@ # T for tone dialing